1980 Toyota pickup part out

[toyotacrawler31]

Parting out what's left of a 1980 Toyota pickup. Don't have much left will list what it has. Larger items will need to taken off the truck by the buyer, I will help as much as I can but severe back and neck issues restrain me from lifting heavy.

Front fenders, cut on the front, bent on the lower rear from tire contact, left has a small dent near where the hood meets, good marker lights. $100 for the pair

Newer headlight bezels and grill, in good shape, grill is painted green but it's peel off paint. $20

Bed is dented, rust underneath the rails and other places, bobbed 14" iirc, hole cut for a stack. The bed is in reasonable shape but still usable for a crawler. Also have a side latch tailgate, has some rust but surprisingly the hinges are in good shape, the tailgate is still in decent shape, I would like to keep the tailgate but if someone needs one I'll sell, it has the the tailgate side holders and chains but missing the latches, I may have latches. Bed $200, tailgate $100.

Hood is in pretty decent shape, has a little rust under the front lip, can let the latch go with it. $150

Cab floor is in pretty rough shape, still has a decent dash, good windshield and sliding back glass (it is blacked out with paint but should come off) if someone needs a cab for the parts I'll do $150, I do have a title but can't remember if I ever sent it off.

Factory push pull power steering box, reservoir, pump, lines, and frame bracket. Box moves freely, not sure what shape it's in though. $100

Two sets of spare doors. Red ones have some rust on the bottom, one has rust on the outside, both of those have inner door panels and all internals. White ones are wing window doors, one is missing the wing window glass but the window mounts are still there, has windows and regulators but no door panels. $150 for the white pair, $100 for the red pair

Set of half doors, very crudely made and dented but work. Could finish lining the inner part and have a decent set of half doors. $40

Still has front and rear axles, rear is factory SA 1980 width. Both are welded. I really want to keep the front axle but if someone needs one make me an offer good enough that I don't want to keep it. I also have an ifs rear, the front has 4.10 and welded iirc, rear is welded and 4.10, ifs rear is 4.10 open. Make an offer and take all 3, but it has to be a good offer. Not selling them cheap cause I'd rather keep them.

Factory length rear driveshaft $100

Located in Kernersville NC

If anyone needs anything make an offer so i don't have to scrap the stuff.

I know it's a long shot but if anyone happens to have a set of Chevy 1 tons and needs the whole truck I'll work out a deal with cash on my end. Truck sitting on the axles, all parts listed plus the ifs rear. The truck has older all pro off road 5" springs front and rear they have surface rust but have never been used on the trail they are new but have been sitting for years, (I built the truck 15 years ago but never used it), although I need them I will let them go in this deal if I have to, these springs are terribly expensive with shipping these days, I just want a set of Chevy 1 tons.

 

[Hellnback]

Do you have the front driveshaft