The successful pieces so far (not for Dusty). The piece on the left is the horizontal stabilizer (well, kind of the rudder too, it's a v-tail plane). At about 75% I looked at it and could see minor movement in the top as it was printing, can't believe it finished successfully honestly, when it finished I could flex the top back and forth 1-2cm. The top isn't as pretty as the bottom but it is sufficient. There is a carbon fiber rod that goes inside it to stiffen it up.
One thing I found odd, Cura said the print time was 2 hrs 8 minutes, but it actually took 3:02. Only reason I am still up at 1am tonight....
