About to install yota axles

mcrawford2010

New Member
Joined
Apr 15, 2010
Location
Raleigh/Rocky Mount
So, I have finally come across some toyota axles and will be putting them on in the near future.

Since the years from front and rear are different, I will be checking the gearing on them to make sure they match up.

I also have a toyota cv shaft that I will be using, with some adapter most likely.

My question is, would there be anything else that I would need to consider to make this a drivable vehicle on, and off the road.

Anything I should pay particular attention too, or tips on the swap are welcome.

Thanks,
 
What vehicle are you putting these Yota axles under?
 
I also have a toyota cv shaft that I will be using, with some adapter most likely.


Could you explain this part. If you are using yota axles, then why do you need an adapter. This statement doesn't make sense. What axles are they?

I have a Toyota/Rover hybrid front and rear. Rover housing to keep all my mounts, brakes, and pattern, then toyota inners and 3rd's. MOST yota's come stock with 4.11 (or 4.10, can't remember).
 
Back
Top