buckshot500
Well-Known Member
- Joined
- Mar 23, 2008
- Location
- Clover S.C.
Hey y'all, Did several mods, to upgrade my heep. One of these is to install Mr. Gasket #925D vacuum advance springs in the distibuter. Having never done this before, I took a look at it. It looks like I have to pull the trigger wheel, then disco the linkage, at the vac diaphragm. then remove the plate, to get to the springs. Is there anything else I need to know, besides not losing the little roll pin for the trigger wheel? Is the shaft going to want to fall down into the motor? can this be done without pulling the whole distributer? Thanks in advance, Paul.