Anyone in Raleigh with a mill?

[orange150]

The mounting holes on my Barnes skid are a little off, anyone around Raleigh have a mill and some time this week that could make the changes? I'd love to get this done by Friday so I can work on the Jeep this weekend.

I work off of Pleasant Valley Rd, if that makes a difference...

 

[jeepinmatt]

Have you tried bolting it up yet? Looks pretty darn close

I've got a mill right beside my jeep and I'd still grind it with a die grinder instead of milling that.

 

[orange150]

Yea I've tried; it's close but no cigar.

The only die grinder I have is my Dremel, I guess I can try a Harbor Freight special...

 

[DSM Turbos]

You can even use a drill as a worst case scenario to open those holes up.

 

[NickMaul]

I have no mill either so I ordered a carbide die grinder burr. Pretty good at opening up holes. Takes a little bit of patience but it works. Amazon has the best prices obviously.

 

[Black Bear]

Northern has them too. They call them deburring bits that come in a set of 5 or 6.

 

[Tom@Hilltop_Machine]

I've got a mill right beside my jeep and I'd still grind it with a die grinder instead of milling that.

X2.

 

[orange150]

I Harbor Freight special'd that bitch. Took less than an hour and cost roughly $30. Thanks for the heads up guys! I had no idea that tool combo would make that so easy.