Axle Builders?

Seeing Red Again

Well-Known Member
Joined
Apr 2, 2005
Location
Holly Ridge
Any axle builders in NC or around the region that could build a front axle for me? I tried to take time to build some waggy 44's but my 65+ hour / week job turned it into a never ending project. I'm contemplating getting someone to build a front D44 that I can just bolt in and save me the time.
Any ideas or opinions? :confused:
 
Andy (zubz) at Carolina Rock Shop here in Charlotte can...

I'm guessing there are a couple others scattered around the state, but he's five minutes from my house so that's where I always start...

Greg
 
I got a stuffed set of axles for sale that would make your jeep a beast :driver: fronts a Waggy 44 w/ 8 lug Conv, rear is a 14 bolt FF Cab and Chasis so it matches the front's width they were made for spring over and come with Ubolts and roller tires/rims to bolt it all up :driver:

http://www.nc4x4.com/forums/showthread.php?t=12705

its obo so if your interested make an offer, ya never know ;) , but otherwise I second Andy at CRS to get it done for you
 
Quite a few around, look in our vendor section to see a list of various builders.

http://www.44magnumoffroad.com/default.asp
Bill does a good job

I know Sheldon at GoferitOffroad.com also works with Kevin Watts some as does DC4wd.com (not sure which Kevin works with the most, etc)

Andy Zuber at CarolinaRockShop has already been mentioned too...basically go check out vendor section for a good starting list....

Sam
 
Back
Top