Carolina custom clad for sand-blasting and powder coating

RHSCTJ

RHSCTJ

Well-Known Member
Joined
Jul 1, 2008
Location
ROCK HILL, SC
Just picked my jeep tub up from them and it turned out great. Anyone in the charlotte area considering powder coating or sandblasting should give them a call. They blasted the whole floor pan and underside for $125 and it had bad rust spots in the rear wheel wells.
STS - Carolinas Custom Clad (CCC)
 
I wish they were closer to our end of Charlotte (the North edge), they're about 40 miles away from us. Glad to see local powder coaters out there doing good work.
 
Did they end up doing it twice
 
Here is a jeep that they powder coated
ImageUploadedByTapatalk1440186320.744700.jpg
 
What kinda coin would it cost to powder an entire tub?
 
I'm sure steve remembers but I think it was around 1500. The only thing I didn't like about powdercoating the body was it bakes all the seam-sealer out of it. And Mine better look like a shit-beat rock missile or I'm not doing it right.
 
Last edited:
Scottie just had to retouch a few areas the humidity got. @jeepyj1129
 
Every thing but the wheels and axles was powder coated it cost $1200 and some change
 
hrmmm....thats cheaper than a good paint job and a lot more durable.
ideas....
 
@Ron that's why we went that route they also used a primer and a clear coat it was the first whole car or tub ever done it was featured in a powder coating magazine
 
Back
Top