Cutting np205 input shaft for doubler

Clubbs

Well-Known Member
Joined
Jun 15, 2008
Location
Blounts Creek
Finally considering the 203/205 doubler. I've been collecting parts for 10 years and have a big bearing 32 spline figure 8 np205. Trouble is the input shaft is the long one. I would think I could just cut it down some and use it without buying a new short shaft. Anyone done this? Is it splined all the way?
 
Well ORD says it won't work so I'll have to actually spend money on something this time. Unless I find a short 32 spline laying around or another 205. Got this one for next to nothing probably over 10 years ago.
 
Back
Top