Cutting & Turning C's on KP Dana 60

NcTrey133

Active Member
Joined
Jul 29, 2019
Location
Mebane
Hey ya'll,

I pulled a Chevy dana 60 and 14 bolt from a buddy in PA a few weeks ago and I've got it all stripped down and will be getting it prepped up to go under a buggy. Once I get the chassis in 4-5 weeks, I'm going to mock it up and point the pinion at the Tcase to get it raised up some.

I was wondering if anyone on here has any experience cutting & turning the C's on the Dana 60? If so feel free to reach out, I could probably attempt to butcher the job myself but if someone has the skills and the price point is ok this is something I'm willing to sub out!
 
ECGS does this stuff a lot. Prices were reasonable the last time I inquired about it.
 
Im getting ready to do this same thing on a gm60. Im narrowing it some on the long side and am going to have sleeves made for it as a "knock in with a hammer fit." Will most likely do the short side the same way even though the length wont change just so I can set caster and pinion angle to my liking. Ive never done this before but should be pretty straight forward.
 
Back
Top