damn tranny clutch crap issues. where to get inertia ring

[Erik]

ok, got an ax5. i'd replace it except i haven't broken it yet and i don't see a point.... so..... that being said

i'm replacing my rear main seal (leaking), clutch, pressure plate, clutch slave cylinder, and hopingt o get my flywheel resurfaced. if i cant get it resurfaced i'll be buying a new one

now... i want an inertia ring.... where is the cheapest place to get one? anyone have one for sale? any downsides of getting one? it seems like a good idea for my 4 banger on 39's....

-Erik

 

[J.C.]

Good idea, especially with the 4 cyl and the fact that you are in the clutch already. I installed one last year. I think if I wasn't geared so low I would have noticed more improvement. Got mine from Jason at Tri County Gear, http://www.tricountygear.com/main.htm , seems like it was $145 or so. If you have a machinist friend it would be easy to make one.

 

[Erik]

unfortunatly, i don't have any machinest friends..... so if i do go to a machine shop i'll probably get bent over pretty bad.

i'm waiting to hear back from jason @ tri country... hopefully they can get me taken care of.

i really want to keep the 4 banger just to be the underdog (oh, and i'm poor) so it makes sense to add one while i'm in there.... or so it seems.

 

[J.C.]

Yeah, despite the continual temptation to be like everyone else with a SBC, I actually enjoy wheelin the banger and it makes it feel even better when you make a hard line

 

[Erik]

just called.

$155 and available at the end of march.

well it was a nice thought.... too bad it never made it past the "i want it" stage.

going to get a clutch and get my flywheel resurfaced. hopefully i'll have it back on the road today or tomorrow if the flywheel takes longer than expected.

 

[strange1]

unfortunatly, i don't have any machinest friends..... so if i do go to a machine shop i'll probably get bent over pretty bad.

Doesn't hurt to ask the guy resurfacing the flywheel if he can do anything for you.