dana 30 axle truss

I was hoping you would put up a pic of that one. I didn't have any pics to post.
 
Looks good guys nice work.


Ive welded one on for a customer before and they seem decent for what they are. You'd be better off with something that braces both sides of the upper control arm mount like the one Matt and Justin did.
 
jeepinmatt said:
Haven't used the Rusty's one, but here's one I just built:
Click to expand...

Matt,

I'd really like to have an Axle Truss like that......

.............wait....that's mine :)

Ohh yeah...post a pic of the CA skids you made for it as well...those look nice as well.

That Rusty's one looks like :poop: I wouldn't think it's worth it at all.
 
Airdoc said:
Matt,
I'd really like to have an Axle Truss like that......
.............wait....that's mine :)
Ohh yeah...post a pic of the CA skids you made for it as well...those look nice as well.
Click to expand...

Thanks for the compliments guys. I don't want to sidetrack this thread anymore. I'll try to get a little build thread on Airdoc's jeep going tomorrow.
 
Mine

Made from this

ai298.photobucket.com_albums_mm279_burrellsjeep_004_3.jpg_901bb6d5b38c586c2eac4c2431ec9be2.jpg


Cut it like this

ai298.photobucket.com_albums_mm279_burrellsjeep_001_3.jpg_aa594b0225dbea15647f875d1d3969ea.jpg


Turned out ok, other than the ugly welds :flipoff2:
ai298.photobucket.com_albums_mm279_burrellsjeep_002_6.jpg_489b79f291abfd51c64e467b1b6a4a3e.jpg
 
Oh if your interested I had this one made for a few of the guys in the club, Mud Pro Cuts it out, Of course you can get it with out the TJC logo, The measurements are really dead on, I only had to barely touch it with a flap wheel to get it to fit snug, It work for an HP30 or a LP30, Mudpro cut it out of 1/4 inch plate. I think it runs around $25 plus shipping in your case. He should still have it on file or you can email him this pic.


Truss.jpg
 
Mike,

Nice truss on yours - if only I was 3-Linking the front...(jealousy)
 
Back
Top