mnrnr New Member Joined Apr 12, 2010 Location marion nc May 21, 2010 #1 how can you tell a dana 60 from a 70?????? i traded for a set from a junkyard ...... dont know if the rear is 60 or 70........ out of a 97 dodge....... thats all i know about the donor..thanks
how can you tell a dana 60 from a 70?????? i traded for a set from a junkyard ...... dont know if the rear is 60 or 70........ out of a 97 dodge....... thats all i know about the donor..thanks
jackedHB Member Joined Apr 3, 2005 Location Boiling Springs May 21, 2010 #2 There were an awful lot of dodges built in '97. Little more info please.
LONCO New Member Joined Feb 21, 2008 Location Suffolk, Virginia May 21, 2010 #3 It should have 60 or 70 stamped on the housing somewhere, either on one of the webs or on top.
mnrnr New Member Joined Apr 12, 2010 Location marion nc May 21, 2010 #4 the truck was 3/4 ton sorry dont know if its gas or diesel....... the front axle has "60F" cast into it
the truck was 3/4 ton sorry dont know if its gas or diesel....... the front axle has "60F" cast into it
braxton357 Robot Joined Apr 6, 2005 Location Morganton May 21, 2010 #5 Is the rear centersection far larger than the front? If so then it's a 70 or 80.
Hurdt299 Well-Known Member Joined Nov 13, 2006 Location Asheville, NC May 21, 2010 #6 It could also be a dana 80 if it was in a diesel with a manual transmission. It will be stamped in the webbing like stated above.
It could also be a dana 80 if it was in a diesel with a manual transmission. It will be stamped in the webbing like stated above.