DANA 60 REAR question

nathan79

New Member
Joined
Jun 20, 2013
Location
waynesville
I'm putting a dana 60 in my 79 ford it had the 9" but busted i bought an f250 non running and done the knuckle swap my question is will i have to have a driveshaft made or can use the one i have thanks
 
drive shaft will strictly depend on the length. The joints dont so much matter as there are different yokes and cross joints that can make the Driveshaft hook up if there is a Ujoint mismatch
 
FWIW, I swapped a D60 rear for the 8.8 into my old 95 bronco. I the existing shaft was too long, so I took it to the local driveshaft place and had it shortened. Cheapish and easy.
 
Back
Top