Flex plate

[spykosshow]

So I've got a question. I've got a 96 zj flexplate and a 94 torque converter i need to mate. The converter has bolt holes that are at 90 and then one that is at 88* The flex plate has them all at 90*. Can I use my drill press to make the one hole slightly larger to accept the bolt? I reckon it'd be fine since the other three will be the right size and they'll all be tightened up and thread locked.

 

[my87yota]

Anyone? I need to get this done ASAP!

 

[SEAIRESCUE]

Yes, the bolt holes do the clamping. The center of both is where the mating alignment occurs. Typically a precision hole in the flex plate and a precision protrusion on the converter.