Good place to get a couple things sand or media blasted?

[87GMCJimmy]

Got a couple sheet metal pieces that could use a good clean up, pretty small, maybe 4 foot by 2.5 foot if they were flattened out (compound curves though, not flat panels). Wondering where I might could get them blasted for not too bad a cost.

Thanks!!!

 

[ncjeepers]

Dang.
Just had mine fired up this past weekend.
It may be a couple weeks before I can do it again.
New Finish in Norwood is pretty good.

 

[BrianGreen]

99NCXJ used to do dry ice blasting. PM him, he can probably get you pointed somewhere.