+ 2 inches
If you use the rear S-10 springs on a K-5 frame, you should be able to turn them around backwards and this moves the centering pin (ie axle) back 2 inches....done it, got the T-shirt
Just get out your tape measure first and check it out on your springs.
Or you can re-drill the pin hole in your leafs for a couple inches or (not recommended) use offset hole in u-bolt plates
Seen that done.
Or buy some custom springs if you want......Sawsall will Correct all of the above and is the most easiest method..NO tape measure
Needed 
