JB Conversions

upnover

upnover

Grumpy, decrepit Old Man
Moderator
Joined
Mar 20, 2005
Location
Morganton NC
Just installed this set up in my Jeep today.

http://www.jbconversions.com/pages/products/dana300/rear_out.html

EVERYTHING in it we needed for the install.
Very good instructions

Highly recommended for anyone wanting upgrade.

Big thanks to Andy Zuber for getting it to me!
Real big thanks David Minton (3DKrawler) for his help with the install. (OK, he did it, I watched mostly)
 
David didn't "come out" to install mine, I took my Jeep to his shop. I am sure you get get him to do yours too, after all, his busness is Minton's Automotive, in Granite Falls NC
I looked at three different upgrades. The selling points of the JB conversions product were:
Same length as stock, no need to change drive shaft length.
Already set up to accept a T case mounted disk brake
New beefy housing
No machining needed.
No guess work, cut and dry install
If needed, operates at a higher angle with the included yoke.
 
You will never go wrong installing any piece that JB conversions makes. All of there products are super nice and the best quality money can buy
 
Very nice, chip do you have a 4.1 kit in the case as well? Ive been lookin into doing a lowrange and upgraded outputs as well.
 
I have the JB 4:1 kit, and the 700r4/300 short adapter....same good results as chip. kit was 100% complete, good instructions. as said you cant go wrong with his parts..
 
upnover said:
Yes, I have the Tera low 4:1 kit in the 300, and then the crawl box.
Works good.
Click to expand...

geeezzz. thats some reduction there. Im gonna swap over to auto and do the 4to1 then.
 
Back
Top