JK Turn Signals in a TJ

[burrellsjeep]

Anyone do this? I am about to.

Anyone have a measurement of where you drilled the holes in the grill. I have an idea of where, But I just want to be sure the light with have clearance behind it after I cut the hole.

he is a sample pic, trying to figure out the measurements on his

If you know of a write up post it up, I have read through a few, But have yet to see a measurement posted.

 

[tkob1060]

not sure if you've seen these two, first one does state not to go to low on the grille of you wont have clearance behind it but not measurements
http://www.jeepforum.com/forum/f9/turn-signal-relocation-418647/#post3772677

http://www.jeepforum.com/forum/f22/...update-thread-457119/index30.html#post7593858

 

[burrellsjeep]

Thanks I know flatlander on Pirate I will see if he will get me a measurement

 

[burrellsjeep]

I was able to get a measurement on the JK lights installed in a TJ,

I am in the process of doing mine and will post some pictures and more info when I am completed.

From the rolled part of the bottom of the grill to the bottom of the JK light it is 1-3/4" and from the grill to the side of the JK light it is 1-3/4". hope that helps.

This info is from "Slangy" on pirate, and that is his jeep