Axle back under jeep.
Currently located near but not perfect final location. @3.5” up in pics, need to get to 7” up min, maybe 8 depending on steering and crank pulley clearance.
Radiator may be a problem.
This gets me close enough to start working on the full hydro ram and tie rod locations.
Then figure out the radiator interference.
Only had a few minutes to work on it this weekend as life keeps throwing me curveballs.
Still more progress than D-6.
Front frame rails are in but not fully welded. Going to tie the reinforcement plates into the bump stop mounts.
Also going to cut off any extra from in front of the winch, so there is no extra tube hanging off the front.
Thinking of incorporating a tube for sway bar install if needed.
Mainly needed to get something back in to support the grill so I could slide axle back in with stands out of the way.
