need my D44 nuckle machined/drilled/tapped, and crossover stuff

[jonnyB]

i have a chevy fullwidth dana 44 with flat top nuckles. wheres the best place to get the nuckle machined, drilled, and tapped? also wheres the best place to buy the crossover steering arms that bolt to the nuckle? i heard galloways does it, anyone know if they do? and how much?
also, can i just get the arm for the passenger side now and keep the stock tie rod in the stock location, then later on (if i bend the tie rod) get the drivers side arm and move the tie rod above the springs?
and last, whats better for my drag link, tie rod ends, or heims?
FYI this will be goin on a 90 runner with 81 yota rear springs in the front, and maybe someday hydro assist.

 

[paradisePWoffrd]

i had JeepinMatt on here do mine for me, and got the arms from HarshTerrain on Ebay...

yes you can just get the pass side done and run crossover, unless the stock tierod location hits the leafs, and the knuckles are a matching pair...

if you drive it on the road much at all, id say go with TREs...

 

[jeepinmatt]

PM recieved and replied.

 

[ncjeepers]

I have all that stuff...
http://bullgearinc.com/6.html

 

[jonnyB]

i had JeepinMatt on here do mine for me, and got the arms from HarshTerrain on Ebay...
yes you can just get the pass side done and run crossover, unless the stock tierod location hits the leafs, and the knuckles are a matching pair...
if you drive it on the road much at all, id say go with TREs...

thanks, i may get mine from harsh terrain. which ones did u get? im thinkin about goin ahead and gettin the behind the axle tie rod ones, but idk.

 

[paradisePWoffrd]

i just got the regular ones, cuz i only did one side.... but ive thought about the other ones quite a bit...