One-Ton Tacoma

[Tacoma747]

!!!!UPDATE!!!
The new stance:

The new frame:

Cutting the body off near this line on both sides, to make room for the steering box on the drivers side, and just to match on the passenger side. Body is welded to the front bumper in a few places for support.

New engine mounts, I am going to make a nicer looking panhard bracket...

Still have to cut some pie slices of tube to weld in:

Gonna make a taller panhard bracket to even it up more with the draglink

 

[Tacoma747]

Did I mention BEEF? I've been wanting a steering shaft that has slip in it, an old driveshaft and I have a free, SUPER BEEFY slip spline.

Shows the diff guard and 3rd link bracket reinforcement(just sitting there)

 

[Hyperlite]

looks good.

 

[01blktaco]

about time. looks good with the tires wven if it isn't fully done yet.....now the jeep.......it may be a while.

 

[chromerunner]

beefy.................

 

[1stgenxxx]

corey sucks...one tons don't

 

[jdubb]

How bout a piece of flat plate with holes and rounded corners welded over the old frame and new pie pieces to strengthen the side? Should be quick and easy way to tie it all together. Turning clearance for front tires?

 

[doc]

Looks good bud!

 

[broncomania]

sweet