Project Sloan 93 yj

Put in an upgraded 3rd kit to prevent popping out of gear, replaced reverse and 1st gear due to rust pitted teeth, but was surprised to find brand new syncros and bushings. Still replacing bearings, but I’ll save my kit for the spare trans I’m building.

Bucket of mineral spirits for cleaning works pretty good

IMG_2682.jpeg


IMG_2681.jpeg
 
Shreddinlettuce said:
Put in an upgraded 3rd kit to prevent popping out of gear, replaced reverse and 1st gear due to rust pitted teeth, but was surprised to find brand new syncros and bushings. Still replacing bearings, but I’ll save my kit for the spare trans I’m building.

Bucket of mineral spirits for cleaning works pretty good

View attachment 449356

View attachment 449357
Click to expand...
Ha, no spares needed for a 465 they be tanks.
 
Shorter throw, 4 inches rearward, improved shift rails supposed to be smoother. I finally found one that wasn’t 500 after shipping

Uses a different stick too that has a one piece bottom so there’s no tack welds to fail and get sloppy. I found a new stick unbent for $60
 
Installing the trans, about 1/2 inch from home I’m meeting pressure plate resistance or pilot bearing not aligned. It’s a hydraulic clutch and the bellhousing is not attached, so I don’t see any way to depress the clutch.

Is my option to run up the bolts and pray I don’t break a tab off, or is there a trick I’m missing?
 
Shreddinlettuce said:
Installing the trans, about 1/2 inch from home I’m meeting pressure plate resistance or pilot bearing not aligned. It’s a hydraulic clutch and the bellhousing is not attached, so I don’t see any way to depress the clutch.

Is my option to run up the bolts and pray I don’t break a tab off, or is there a trick I’m missing?
Click to expand...
I do mine but leaving the pressure plate loose, seat the trans the slide it back and toque the plate.
 
finally warm enough to get back under the jeep. Found I had enough play to rotate the ear under the trans rib if I clearances the slave cylinder. Clutching awesome!
IMG_2786.jpeg
 
Monkeynono said:
What bellhousing is that? Factory hydro?
Click to expand...
QuickDraw brand, uses stock yj/tj/ram/xj/durango hydraulics fork and throw out, 99-01 Camaro or 4.8l truck clutch and flywheel, works with sm420, 465, t5, tkx, nv3500, nv4500, tr4050 and probably others depending on the hardware you get. It’s a super nice casting too.

Only issue I’ve had is the need to thin out the webbing on the slave cylinder to clear
 
Back
Top