WARRIORWELDING
Owner opperator Of WarriorWelding LLC.
- Joined
- Jan 6, 2008
- Location
- Chillin, Hwy 64 Mocksville NC
Anybody know someone who still does this? I have a fella looking for someone.
Recentering Hummer wheels
- Thread starter WARRIORWELDING
- Start date
paradisePWoffrd
Recovering Project Junkie
- Joined
- Nov 5, 2005
- Location
- Newton, NC
you wont do it? Is he wanted stamped centers or will flat be ok? offroad only or street driven?
WARRIORWELDING
Owner opperator Of WarriorWelding LLC.
- Joined
- Jan 6, 2008
- Location
- Chillin, Hwy 64 Mocksville NC
No I want do it. I don't have a effective means of truing the center. For the time to get it the way I would prefer I would not make money.
I have become a lot more careful of the work I take on.
No details on the latter.
I have become a lot more careful of the work I take on.
No details on the latter.
lbyota85
Let the chips fly!
- Joined
- Dec 11, 2006
- Location
- Taylorsville, NC
I still have the hub jig we used back in the day. It’s yours if you want it. Even has a arm that holds the plasma torch
marty79
Well-Known Member
- Joined
- Nov 24, 2013
- Location
- Newton, NC
I mean I've done several sets over last few years, came out really well too. That Mounty drove up to 45 no problem with the 42s other than driveshafts not being balanced so if he's looking for "rig" only, I can do it. Street/Highway use I could but won't be as cheap since I'll have to setup a jig which I can cut on my table...food for thought