Th-350 to Np205

Metto

Metto

Well-Known Member
Joined
Mar 20, 2005
Location
Cornelius, NC
i picked up my 205 today, but i am a little confused about how it connects to the Th350. there is a male output shaft on the 350, but the input shaft on the 205 is also male. how do these mate together? is there an adapter sleve that mates the two together? :confused: i didnt get my adapter yet so i dont know what it looks like but from what ive seen there isnt any kind of sleeve. help???
 
I've seen them on ebay. GM can still get them. They can get pricey. Its best to buy the adaptor, tcase, sleeve and shifter all together. I've found that you get a better price. If you can't find one. I've got an extra one but the splines are worn alittle. $25 plus the ride.
 
i didnt get one with my case, or a shifter, but im twin sticking it anyway. and i doubt that i will get one with my adapter (buying from a different person). i may take you up on that, but could you mail it?
 
Yeah I can ups it for prob around $5. Like I said the splines are a little worn but if you can't find one at a decent price, this one will last you a while.

On a side note what are you using as the twin stick shifters. I've been wanting to do that to my rigs but haven't felt like fabbing shifters.
 
im going to get 3/8s rod stock and bend it with my grandpas rod bender. then thread one end, attach BMW shift knobs (hey, use what you got) and weld some 1/8 plate to the bottom to attach to the shift rails. then i will bolt it all up and figure out a mounting point. shouldnt be hard. on a side note, i had my range rail out to grind it for the twinstick mod, and now i cant get it to line up with the shifter inside the case. any ideas on how to make it line up? i did put an allen wrench through the roll pin hole but it still moved over a little bit
 
john nevermind on the sleeve...there was one in the adapter i got from RK today
 
Back
Top