Had to go back and see if I posted it but I didn’t. I do have a crossbar in there and made it so that the tabs actually tie into it. Also, will be bringing a tube out from the dash tube to help with the torsional load there. I am still somewhat worried considering when I roll it that’s going to be the first point of contact. Hopefully it’ll hang in there. It’s about 2” of weld area per side of the tab and made of 1/4” plate. Planning to enclose the mounts on the front and rear with more plate bent to fit as well.
[ATTACH=full]345576[/ATTACH]
[ATTACH=full]345577[/ATTACH]
