Reply to thread

I talked to a guy at TNT and he told me to set the axle at 5degrees and the truss at 0. When I get it set like that it looks way off compaired to the stock mounts. So my question is, Is there a standard setup for the truss under an XJ as far as setting the pinion angle and setting the truss. When I set the pinion at 5 degrees like they said the axle looks right as far as pinion angle and the c's are straight up like my stock axle, but when I put the truss at 0 degrees it looks like it's too far back and this will through the pinion angle off when it's mounted under the jeep. The truss is full length from c to c and the coil buckets mount on top of the truss. The ends where the coils mount are set on a slight angle.