23 spline Toyota 4.7 transfer case

Stuntman Autoworks said:
I have a crawlbox sitting in the shop
Click to expand...
Thanks man! I already have duals, just not a 4.7 case. Pondered the pros and cons of triple cases lots. Rear axle is welded in and somehow swapping the 14 bolt from the FJ80 rear didn’t need a new driveshaft so the triple case idea is just a fart in the wind now.
 
frankenyoter said:
Thanks man! I already have duals, just not a 4.7 case. Pondered the pros and cons of triple cases lots. Rear axle is welded in and somehow swapping the 14 bolt from the FJ80 rear didn’t need a new driveshaft so the triple case idea is just a fart in the wind now.
Click to expand...
I mean shortening a driveshaft is easier the lengthen
 
Monkeynono said:
I mean shortening a driveshaft is easier the lengthen
Click to expand...
Believe it or not, the driveshaft bolted right up with the same rust line as the 80 rear. Zero expense other than perches. However… it is tempting to buy another set of perches. I have to buy a front shaft already.
 
FWIW I would suggest sticking to your original plan and run the duals with 4.7 gears in the rear case. In my opinion/experience Toyota cases generally live on borrowed time in an east coast rig as it is. A third case will only add more breakable parts at the rear of your drivetrain. 5.13 or 5.38 axle gears would be a good way to decrease stress on your t-case parts and reduce the likelihood of breakage. But nothing is gonna stop them from breaking when you dump the clutch in 3rd gear at 4k rpms, lol.
 
1778258820165.jpeg
 
Kickdeez said:
FWIW I would suggest sticking to your original plan and run the duals with 4.7 gears in the rear case. In my opinion/experience Toyota cases generally live on borrowed time in an east coast rig as it is. A third case will only add more breakable parts at the rear of your drivetrain. 5.13 or 5.38 axle gears would be a good way to decrease stress on your t-case parts and reduce the likelihood of breakage. But nothing is gonna stop them from breaking when you dump the clutch in 3rd gear at 4k rpms, lol.
Click to expand...
Ultimately atlas is what I’d like but my wallet disagrees, thus looking to score a 4.7 to not go (more) all in on building a yota case. Axles are 5.38
 
frankenyoter said:
Ultimately atlas is what I’d like but my wallet disagrees, thus looking to score a 4.7 to not go (more) all in on building a yota case. Axles are 5.38
Click to expand...
I've been there, honestly just save up and buy a 4spd atlas and 1410 ujoints and be done. Other than the supercharger you will have the same setup as I do after going through dual yotas, then yota-atlas, and now nwf-atlas (4spd atlas basically). With 5.38 in my axles.
 
Back
Top