Jeffncs
Well-Known Member
- Joined
- Apr 4, 2017
- Location
- Wake Forest
Before I scrap the drums and spend $800 on a disc brake kit, can anyone offer insight on what may be going on with these brakes?
1977 bronco, 9” rear not original to truck. It’s a small bearing setup vs the stock big bearing. Everything is new on the brake system…. Master cylinder, distribution block, hard lines, soft lines, all brake components front and rear.
Front are stock disc brakes for the 77 D44
Rears are 10” drums that I pieced together since the axle only had a bearing retainer left when I got the truck.
Symptoms:
Test drives result in shoes dragging so bad that the drum temps are outside the IR thermometer temp range. I’ll take it all apart, reset everything and it will happen again.
Some add’l notes and thoughts as you ponder my issues….
I don’t typically adjust the brake shoes when putting them back together. Should I?
The shoes are getting displaced from the upper pin (see pics).
I’m missing the little football shaped plates on that same pin (no clue what they do!)
HELP?!?!? I’ve rebuilt brakes countless times and this is just absolutely stumping me!















1977 bronco, 9” rear not original to truck. It’s a small bearing setup vs the stock big bearing. Everything is new on the brake system…. Master cylinder, distribution block, hard lines, soft lines, all brake components front and rear.
Front are stock disc brakes for the 77 D44
Rears are 10” drums that I pieced together since the axle only had a bearing retainer left when I got the truck.
Symptoms:
Test drives result in shoes dragging so bad that the drum temps are outside the IR thermometer temp range. I’ll take it all apart, reset everything and it will happen again.
Some add’l notes and thoughts as you ponder my issues….
I don’t typically adjust the brake shoes when putting them back together. Should I?
The shoes are getting displaced from the upper pin (see pics).
I’m missing the little football shaped plates on that same pin (no clue what they do!)
HELP?!?!? I’ve rebuilt brakes countless times and this is just absolutely stumping me!














