Anyone in hickory area able to line bore a 22r ?

khwrx

Active Member
Joined
Dec 10, 2006
Location
lincolnton nc
im lookin for someone that can line bore my 22r that im rebuilding for my buggy. heres some back story, anyone that has seen my buggy has heard the rattling up the trails. well this winter i decided to tear it down to investigate . come to find out who rebuilt the engine before i owned it turned the cranks mains and rods 10 thousandths and put standard bearings in it . well no damage was done so i bought the right size bearings and after i torqued the crank down it wouldnt turn. had a machine shop check out my problem and #1,2,4,5 main caps are close to 5 thousandths to small.
 
Not sure it this will work for you but... I built an old BMW airhead motorcycle a few years back and had a CarQuest to the machine work for the engine. They bored it out and did the valve grind.

Good luck!
 
kinda a drive for you but engine
service in shelby can do it for you.
i've used them many times.

pm me if ya need a number.
 
Back
Top