Anyone re drill axles ?

[jovibuilt]

I have a nine inch ford rear with 5 on 5 bolt pattern.I want to re drill the axles and rotors for 5 on 5.5 can anyone recommend a shop?

 

[userbmx1315]

what did the 9" come from? what about shafts from another vehicle?

 

[zombhntr]

A full width 9" should be 5on5.5 did u mean you want it drilled for 5 on 5" not to be a smart ass just saying

 

[braxton357]

Moser will redrill axles. I'm not sure if you could fit 5x5.5 with the retaining flange hole still there? What did a 5x5 axle come out of anyway 70's car?

 

[jovibuilt]

Moser will redrill axles. I'm not sure if you could fit 5x5.5 with the retaining flange hole still there? What did a 5x5 axle come out of anyway 70's car?

Yep a 1978 town car.It is 5 on 5 with disk brakes.64"wms to wms I want to re drill the axles to match my dana 44 front.I know Moser can do it.I was hoping ecs or someone closer could do it.

 

[userbmx1315]

a local machine shop can do it. not sure what it would cost.

 

[shawn]

Moser will redrill axles. I'm not sure if you could fit 5x5.5 with the retaining flange hole still there? What did a 5x5 axle come out of anyway 70's car?

Probably 28 spline, too. Might be worth it to just get alloys made in the right bolt pattern with 31 or 35spl shafts.

 

[THE guyrock]

call foothills 4x4 in Greenville sc. They have done lots if custom stuff with axles for me over the years.

Sent from my SPH-D710 using Tapatalk 2