Bent trailer ramps

jscrayto

Well-Known Member
Joined
Aug 18, 2006
Location
kannapolis
Just bought a 16 foot trailer with slide under ramps. The previous owner used the trailer to scrap junk cars and bent or arched the ramps. The ramps are 4 feet long made of angle iron. Any suggestions of how to straighten them back out?
 
flip em' and apply weight. Or large fab table clamp one end down, block up the middle, clamp other end and apply heat at several locations with a rose bud until straight. Or put a chain on one end run across abottle jack in the crown and chain to other end, jack until straight.
 
I'll try the bottle jack and chain. Parked my truck on top of them in the driveway but my Titan is not heavy enough to do anything.
 
Back
Top