Caney Fork - WCU

Mine's got a lil over 5" on 33's.. full widths and 3 link being fabbed up..

I sheared the bolts from my motor mount in the block commin down off Caney Fork... that's going to be fun in the parking lot this week...
 
I WANT full widths BAD! Want to go Chevy axles, dana 300, and 350 tpi, but funds don't allow at this time! LOL! Why do you have to work on it in the "parking lot"? I have a ton of tools and air if you need it? ALWAYS willing to lend a hand!
 
I'm having to run a 150 ft of extention cords out my dorm window to reach it and its been a bitch so far... I'm borrowin Brandon's compressor and angle air drill at the moment.. If it was inside or under a cover it would be so much better... layin on that asphalt against the car next to you's tire is no fun, lol..

Do you have an engine hoist? May need it to get the motor back up..
 
I'm in sylva aswell and actually have a truck to wheel now,(range rover truggy on 37's) so we need to get up and wheel sometime.

I was up at caney fork the past two days and am suprised I didn't run into yall...

Send me a pm if you ever want to wheel
 
Back
Top