chevy 63 spring swap shock location

andrewhove

New Member
Joined
Jan 24, 2008
Location
Durham
I know this topic is talked about a lot but I can't find good info on shock mounting. I did a U bolt flip so I have no mount for the bottom end... I bought some TG mounts but their holes are smaller than holes in the stock toyota shocks (therefore I now have different diameter mounts top and bottom). trying to run a 12in travel shock off a Dodge half ton.

What are people doing for the upper mount if I want to keep the shocks in their stock location and not inboard them
 
Think you'll probably have to inboard them unless you go through the bed. I had new tabs welded on top of the axle and had to inboard them because I wasn't quite ready to go through the bed.
 
Back
Top