uncc civilengineer
Well-Known Member
- Joined
- Jun 28, 2006
- Location
- Pfafftown, NC
Anyone close to Winston that can check out my 10" Fox 2.0 Coilovers? Just trying to see what pressure's in them and if they need some oil/nitrogen/etc? ... The front end just seems a little too soft.
Im running :
*Fox 2.0 Emulsion w/ 0.875" shafts
*8" / 2.5"ID/ 300lb top
*12" / 2.5"ID/ 300lb bottom
Currently setup for 5" Up/5" down and I have 1.75" of thread remaining above the locknut (IE I could lower it if need be but would rather not).
Again, like I said i'm just trying to see where I should be w/ pressure, etc. It's a full bodied Nissan Exterra (V6, etc.) Or are my spring rates too soft?
Also, is it worth going to reserviors?
Im running :
*Fox 2.0 Emulsion w/ 0.875" shafts
*8" / 2.5"ID/ 300lb top
*12" / 2.5"ID/ 300lb bottom
Currently setup for 5" Up/5" down and I have 1.75" of thread remaining above the locknut (IE I could lower it if need be but would rather not).
Again, like I said i'm just trying to see where I should be w/ pressure, etc. It's a full bodied Nissan Exterra (V6, etc.) Or are my spring rates too soft?
Also, is it worth going to reserviors?