dana 44 narrow trac parts

[1983Bronco]

I need a drivers side rear axle shaft for a Dana 44 narrow track. Is there any aftermarket for these or am I just gonna have to go boneyard on this one? Also where there different spline counts for different years? Thanks

 

[paradisePWoffrd]

is it 1 piece or 2?

http://www.jeeptech.com/axle/d44.html

may not be the easiest to find in a bone yard...


here's something I ran across...
http://www.reiderracing.com/index.php?cPath=5984_6127_6128_6177

but someone locally might can get you one though...

 

[1983Bronco]

is it 1 piece or 2?

http://www.jeeptech.com/axle/d44.html

may not be the easiest to find in a bone yard...


here's something I ran across...
http://www.reiderracing.com/index.php?cPath=5984_6127_6128_6177

but someone locally might can get you one though...

Good info, looks like its the centered Dana 44, so I guess its one piece 30 spline, do I have to press the bearings on and off?

 

[Caver Dave]

looks like its the centered Dana 44, so I guess its one piece 30 spline

Sounds right...

do I have to press the bearings on and off?

Skip reusing them, just buy a new bearing, outer race, & retainer. Assemble in correct order for YOUR axle (some backing & seal plates must go on first), bearing (w/ taper *inboard*) & finally the retainer... pressing the bearing , then the retainer on separately... clean the axle tube & green loctite the inner race in (IMHO, save a lot og headaches later)

 

[Cperry]

Paging Brad: Call me ill hook you up

 

[1983Bronco]

Paging Brad: Call me ill hook you up

I might have the problem solved, I'll let you know this evening. Thanks