dirveshaft question

[userbmx1315]

it wont be long and ill be adding drive shafts to my jeep.
my only issue is the rear, its a 14 bolt with the huge 1410 or w/e. and the other side is a dana 300 with stock yokes. (1350?)

i really dont have the money to go custom shafts.
how can i make a shaft? ive seen square tube inside another,
also have seen one shaft slid over another and welded.

any ideas? this is a trail only rig, aka trailer queen, crawler.

 

[willness33]

The 300 probably has 1310 yolks. You can probably just get a junkyard shaft that uses 1310s and throw a bastard joint (1310/1410 joint) for the14 bolt. I'm not entirely sure what sizr joint the 14 bolt uses but I don't think it's as big as a 1410.

Ok, a quick check showed the stock 14 bolt yolk is 1350. You can buy 1310/1350 conversion joints pretty easily.

 

[userbmx1315]

spicer make them? were does everyone get there spicer parts?

 

[willness33]

Locally? Dont know. Order them from ECGS.

 

[Benjie]

Definitely go ECGS.

 

[andybritt2002]

14 bolt is usually 1350 if its stock

 

[R Q]

Its called a conversion joint. I got one at NAPA, 1350 to 1310. Just buy two so you have a trail spare.

 

[Tom@Hilltop_Machine]

I have a 1350 yoke for a dana 300 if your interested. That way you can run 1350's at both ends and have a stronger shaft.

 

[userbmx1315]

I have a 1350 yoke for a dana 300 if your interested. That way you can run 1350's at both ends and have a stronger shaft.

if i would have seen your post i'd have got it.
i ordered a conversion joint from ecgs.
doesnt everyone run np231 yokes for the non threaded holes?