Ford 9" brakes

[family xj]

Does anyone know the size of the fitting the screws into the back of the drums. I am also trying to figure out the size of the hard line. Just trying to get my brakes done on my conversion. Thanks

 

[mudonthetires10]

I did know, but I keep forgetting. I'll see if I can check again on the hard line. Is that the only thing you're looking for?

 

[family xj]

Yeah. My axle only had the ends that screw into the drums and the lines were cut. I will reuse the Jeep rubber line and then mate them to the Ford hard lins. Thanks again.

 

[mudonthetires10]

I do know that I had to replace the small piece of hard lines that went from my stock hard line to the drum itself. I just went into Advance Auto and they have pieces that mate right up.
I'll see if I can't find the size though.

 

[Black Bear]

Its a standard US fitting for 3/16 hard line. I think its 3/8x24tpi

 

[family xj]

Thanks everyone. I got the lines fixed today. Now I can't get the bleeders loose. Might end up replacing the wheel cylinders.