Ford D44 Front help.

[ghost]

You need to ditch those lock washers and flip the nuts on the high steer arm. Those are conicle nuts that center the studs assuming the high steer is machined for the nuts in that way.

I'll look into that but....

They look like conical washers and lock nuts.

Duane

I think you are right. Will double check it when I get everything fab'd up.

 

[77GreenMachine]

I didn’t even know conical lock washers were a thing. But if so, carry on.

 

[Croatan_Kid]

You've never seen these?

Dana 44 High Steer Arm Install/Stud Kit

Sky's Off Road Design Dana 44 9/16ths high steer stud kit.The fact is, stock Dana studs were not designed for extreme use.So grabbed some chromoly bar and started making our own studs.We start by cutting and threading the material, then it goes to heat treat for through hardening and then a...

www.skysoffroaddesign.com

 

[77GreenMachine]

You've never seen these?

Dana 44 High Steer Arm Install/Stud Kit

Sky's Off Road Design Dana 44 9/16ths high steer stud kit.The fact is, stock Dana studs were not designed for extreme use.So grabbed some chromoly bar and started making our own studs.We start by cutting and threading the material, then it goes to heat treat for through hardening and then a...

www.skysoffroaddesign.com

Yes but I thought I was looking at standard lock washers, but I could just be seeing the tops of what you linked.

 

[Croatan_Kid]

Yep. That's pretty much exactly it. I get it.