h2 rims

[Bullardbs]

I got some h2 rims for my 79 f250 how can I make the centers fit over the hubs without taking it to a shop and paying for it

 

[paradisePWoffrd]

they will probably fit over the d44 fine... but not likely the 60... in order to do it right, and be balanced, they really need to be in a mill/lathe...

yager did this: http://www.nc4x4.com/forums/showthread.php?t=64201&page=2 and you might have some luck doing it as well...

 

[Bullardbs]

anyone know how big the hole needs to be for a dana 60 rear

 

[MichaelT]

They would not fit over my 10 bolt front

 

[Bullardbs]

I just need a chep way to make these work

 

[GSW]

I think it's 4.774" for the newer Dodge hubs. I've seen in done with routers and a special bit, or even with a hole saw. You might be surprised by checking with a few machine shops anyway. They may be hard up for work and willing to deal.

 

[doc]

I told ya'....j/k

I may have a hook-up on these...let me check.

 

[Bullardbs]

I told ya'....j/k

I may have a hook-up on these...let me check.

I know but the guy said they were on a old chevy one ton when he bought it but o well

sounds good let me know?

 

[jeepinmatt]

You could do this:
http://www.nc4x4.com/forums/showthread.php?t=17239
A little time consuming, but kinda entertaining at the same time.