head work

utah

Active Member
Joined
Mar 31, 2007
Location
waxhaw nc
I have a set of vortec heads I was thinking of porting and pollish them. I was thinking of doing it myself ( it would be the first time) Or is it smarter to have a shop do the work. If so whats the going rate for head work.
 
ports arent that bad to do,just place the gasket to the head and mark it with a fine pionted sharpie and cut away to the marks...do the intake the same way.
the combustion chamber is tricky due to getting the CCs in each cyl off alittle which would give that cyl more/less compression.which can unbalance the motor.
 
Back
Top