intermediate shaft help!!!!!

crawlers10

New Member
Joined
Mar 29, 2009
Location
China Grove nc.
i need a shaft made to go from my gsxr 600 bike motor outout shaft to the input shaft of the trans i am using. is there any one out there that can drill a solid 1 1/2 round tubing and spline the inside of the shaft for the input and out put but any ideas would be gawsome and thanks for lookin.

oh its a 06 motor going in a 84 datsun 720 truck
 
holler at John Thomas......he put one in a Sami
 
Use a sprocket for the engine side, and the center hub of the clutch for the other end. That is what John Thomas did.
 
Back
Top