scjeep
Well-Known Member
- Joined
- Oct 11, 2005
- Location
- Conway, SC
I picked up these axles in hopes of running in my Gladiator. I was planning to remove the rear axle brackets and swap to JT brackets. But my plans have changed.
Figured I would put them on here and see if anyone is interested.
Front and rear JL Axles.
No brakes or knuckles.
RCV one piece axles up front
RCV CAD block off plate.
Metalcloak CAD Skid.
Dynatrac Rebuildable Ball Joints up front (May need to be rebuilt I haven't looked at them yet)
Metalcloak Rear Axle Skid
ARB Diff Covers on both axles
Front Rockhard 4x4 Lower Control Arm Skids (One has been notched by previous owner but not a lot)
Front and Rear Driveshafts for a JL - Rear is an Adam's Driveshaft (1350 joints) and front doesn't have a label, so I assume it's a cheaper brand. (1310 ujoints)
Also has the flange for the rear shaft at the TCase and a new yoke on the axle for the rear shaft.
I have not ran these yet myself, but the internals look good.
Dana 4.88 gear set installed in both with factory rubicon lockers.
Would be a nice near turn key setup for a JL.
Looking for $5,000 for the set. I am in SC but I am in NC every couple weeks near Wadesboro.
Figured I would put them on here and see if anyone is interested.
Front and rear JL Axles.
No brakes or knuckles.
RCV one piece axles up front
RCV CAD block off plate.
Metalcloak CAD Skid.
Dynatrac Rebuildable Ball Joints up front (May need to be rebuilt I haven't looked at them yet)
Metalcloak Rear Axle Skid
ARB Diff Covers on both axles
Front Rockhard 4x4 Lower Control Arm Skids (One has been notched by previous owner but not a lot)
Front and Rear Driveshafts for a JL - Rear is an Adam's Driveshaft (1350 joints) and front doesn't have a label, so I assume it's a cheaper brand. (1310 ujoints)
Also has the flange for the rear shaft at the TCase and a new yoke on the axle for the rear shaft.
I have not ran these yet myself, but the internals look good.
Dana 4.88 gear set installed in both with factory rubicon lockers.
Would be a nice near turn key setup for a JL.
Looking for $5,000 for the set. I am in SC but I am in NC every couple weeks near Wadesboro.