Well now that my life is less eventful I’ve gotten around to tacking some stuff under the JK, tomorrow I’ll have to cut the floor to see about mounting the uppers. I’m likely going to put a bend in my uppers to clear one of the factory crossmembers, but won’t know till the uppers are mocked in the right position. But today just worked on the lower link crossmember then had a few friends stopped by which distracts me from getting things done.
I may have to clearance the frame for the Lowers, but again I’ll sort out a lot of stuff once I can cycle it, just a good bit of work to get to the point. And loving having the plasma cutter and dialing in the amps so I can just gauge out a weld and knock the bracket off.
