Metal Suppliers in the Triangle

[bengreve2001]

I'm trying to find somewhere in the triangle I can get a 6x6x1/4 piece of angle iron but I think i'm just looking in the wrong places. I only need a 10' piece. Any suggestions?

TIA,
Ben

 

[Rich]

Apex steel sells small quantities, but it's pricy.

You might run out to DH Griffen in greensboro...

 

[getstucksome]

you can check with dillon supply in raleigh, I've dealt with them in the past and they've had pretty good prices.

 

[bengreve2001]

Thanks for the quick responses guys! I'll give them both calls tomorrow.

 

[Black Bear]

Foy mart, just out side of raleigh on 64E. best prices around, but their selection isnt the greatest. they used to have a 4x6x5/16 20ft for 109.99, but they dont carry it anymore

 

[Newbie]

Dillon only sells in full length sticks (20ft min) There is/was a place on Gresham Lake rd that would sell in any lenght but dont really remember the name right now. If it were me I would go to TT&E and find it in the scrap yard since its a fairly common size and it will cost nearly nothing that way too. SB