Need a router bit...

[R Q]

I built a deck on my house and need a router bit to trim the edges of the 5/4 decking board flush with the 2'' x 10'' frame under them. I want the bit to have the wheel on the end to follow the 2'' x 10''s but to trim the 5/4 board with the same round edge as they already have. What is this bit called?
I hope this makes sense, my carpentry terminology probably isn't up to snuff.

 

[shawn]

It might have to be two bits - use a flush cut with a roller end first, then come back on a second pass with a round-over bit of the appropriate radius to match what's existing.

 

[R Q]

It might have to be two bits - use a flush cut with a roller end first, then come back on a second pass with a round-over bit of the appropriate radius to match what's existing.

OK can I get the round-over bit with a roller end on it also so I don't gouge my edges?

 

[shawn]

OK can I get the round-over bit with a roller end on it also so I don't gouge my edges?

Yeah, they usually come with roller ends on them.

 

[R Q]

Yeah, they usually come with roller ends on them.

Great thanks!

 

[getstucksome]

Harbor freight has a whole set of those for pretty cheap. I have that set if you needed to borrow a bit.

 

[ncsutj]

I've got a 1/4" round over bit if you want to borrow it.

Sent from my SAMSUNG-SM-G930A using Tapatalk

 

[GotWood]

Klingspor Woodworking had everything your heart could desire.

 

[rodney eppes]

Woodworking Machinery & Supplies



Directions
Save
5.0Address: 290 Beatty Dr, Belmont, NC 28012
Hours:
Closed ⋅ Opens 9:30AM Tue
Phone: (704) 827-3190

Also, I have a router bit set, but not sure what you need. Your welcome to look & borrow. 704-822-3527

 

[Black Bear]

Lowes had the bits you need.

 

[R Q]

I've got a 1/4" round over bit if you want to borrow it.

Sent from my SAMSUNG-SM-G930A using Tapatalk

Thanks but I'll buy the ones I need, I hate to borrow things!