Need help with a couple bends on 1.25 x .120 tube

[GTTJ]

I've got an '03 TJ that I've had since new. I've done a fair amount of work on it but it's been sitting in the garage for quite some time. I finally got the rear main seal replaced(again...) and it's back together. I'm trying to do a couple other things to it with parts I've had sitting around for awhile. I've got some tube fenders for it but they don't have a flare on them that I'd like to have. I have the tube but need help bending it.

Anyone near Greenville, NC have the ability to bend 1.25X.120 DOM and doesn't mind helping me out. 6 total bends.

Thanks for any help!

 

[rockcity]

Got the bender and in Gvegas, but no 1.25" die.

 

[Mac5005]

Got the bender and in Gvegas, but no 1.25" die.

You can make a shoe with a piece of 1.75 .250 wall.

 

[rockcity]

You can make a shoe with a piece of 1.75 .250 wall.

That sounds like work!

 

[GTTJ]

Probably is... I'm more than willing to help where I can. Can't imagine I can by a foot of it but I'll look. I've got a small bandsaw that I can cut it in half as well.

 

[rockcity]

I forgot my bender is in Charlotte with @YJJPWrangler

 

[YJJPWrangler]

@rockcity, I'm actually gonna put it to use here shortly...