Need rod ends for homefab upper control arm XJ

NickMaul

Well-Known Member
Joined
Jul 4, 2009
Location
Norfolk, VA
Hey NC4x4. I am going to make some upper control arms for my XJ on 3.5" lift and was looking for a vendor who supplies currie johnny joints. I know of all the vendors who supply heims but I do not wish to go that route. I have left over DOM from a steering upgrade and need a threaded johnny joint or threaded bushing in the 2" width flavor so I can adjust caster and pinion angle.

Any vendors on here to help me out?
 
@Barnes 4wd has their Enduro joint, which is quite possibly better than a Johnny Joint, and comparable or lower in cost.
 
you can buy a set of adj. uppers on ebay for $100.
 
Back
Top