NP205 yokes

[Rich]

I thought the stock yokes on a 205 (from a TH350 if it matters) were 1310 CV front, 1350 non-CV rear?

Mine has a 1310 on the back... With the gearing, I'm OK with a 1310 front shaft, but the rear needs to be at least 1350.

 

[kaiser715]

I got a divorced 205 on my shop floor, 1310's all around. Think it came from a Ford.

 

[Jeff B]

I'v had 2 np205's both had 1310 front & rear 1 was chevy & 1 was ford but both were from the late 70's or early 80's

 

[Rich]

strange... oh well.. it's not like no one makes flanges that fit a 205..

 

[BIGWOODY]

You'll never give it enough throttle to worry about needing anything bigger than a 1350....

 

[Rich]

You'll never give it enough throttle to worry about needing anything bigger than a 1350....

Riiiight.

 

[91oneton]

go 1410 . thats what i ran because thats what the rocks run factory

 

[ghost]

when I ordered my shafts from Tom Woods this week he told me to measere bc it varries. Especially in 78 and 79 205's. Mine has 1330's on it.

 

[86m1008beater]

My np205 from a 91 1 ton had a 1310 yoke on the back until it snapped in half. It now has a 1350 yoke but I should have put on a 1410. I do moronic things sometimes..

 

[broncomania]

he told me to measere bc it varries. Especially in 78 and 79 205's. Mine has 1330's on it.

if your talking ford 205's the 78's were 1310 and 79's were 1330.

 

[CrashKnott]

hmmm, well some more strange insight...I have a 205 from a 79 Chevy, and it's got a 1330 front and 1350 rear.

I bought a parts truck that was apparently used and abused more than I knew, but I doubt the PO went through the trouble of replacing a 1330 rear yoke in exchange for a 1350 when he was only on 31" MT's.