Poly-Performance 4 link users?

ncgamedog

ncgamedog

Well-Known Member
Joined
Oct 30, 2005
Location
Greensboro, NC
Anyone running this? Looks like this would beat the snot out of the typical LA's. The LA's I have seen unload something terrible. I would like to do this on my MJ and SOA in the rear. I only want to net 4-4.5" lift (to keep it low). I will proabably try explorer rear springs using my 2wd main leaf in the rear for less lift. If I have to I might consider spring sliders to keep the rear around 4".
http://www.polyperformance.com/shop/...t-p-20915.html

I'd like to see some installed pics if anyone has some, or likes/dislikes

thanks -J
 
thats looks good. the radius arm we did on johnnys jeep dosent unload bad at all. ive seen some raduis arm setups that dont perform at all.
 
good looking kit.i really like the frame mounts but i think its a little pricey for what you get. and yea i am not very impressed with radius arms. they work good on flat ground but tend to wheel hop on climbs and that when shafts start snaping.
 
i bought a iron rock offroad 6.5 inch long arm kit radius arm set up an it flexes like crazy and i havnt had any wheel hop problems i think it stresses the axle brackets more than i like but thats my only compaint so far
 
Back
Top