roll cage

Kap10merica

Kap10merica

Well-Known Member
Joined
Feb 19, 2011
Location
Canton, nc
Can anyone help me. I'm goin to put a cage in my truck but i'm
clueless as to where to bend the tubes or how to measure and wat i need to take in account before i start. :beer:
 
Trial and error(no matter what you will have some). Read up on bending procedures(lot's of stuff on net). Depending on bender you have, most come with some kind of general instrucions on figuring out your lead in, where your center point on your dies are, what the radius's are, ect. I can say measure three times, make sure your bends go the correct way, do not overbend, take your time.
 
Actually if you were closer Id put it in Bend Tech for you so there would be as many problems for you and would make your first time a lot easier.
 
If I could bring my truck to you can you give me a ball park on installing a four point cage.
 
Back
Top